Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-26
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
Step 6 Click on Yes in the warning box and click Ok in the Information box to continue.
Figure 7-33 R6 Interface Warning & Information Boxes
7.5.3.6 Set the Call Admission Control (CAC) Parameters
The steps to set the CAC parameters are shown in Figure 7-34 through Figure 7-36. Please refer to these
figures as you read the remainder of this section.
Step 1 Select Mobility > CAC and then click on Show Configuration and Configure.
Figure 7-34 Selecting the CAC Parameters
Click on “Ok”.
Click on “Yes ”.
Click on “Ok”. Click on “Ok”. Click on “Ok”. Click on “Ok”.
Click on “Yes ”. Click on “Yes ”.
Click on this ico n to open t he “Mobili ty” branch of the t ree.
In order to make changes, click on “Configure”.
Click on “Show Configuration”
to view th e current CAC
configur ation.
Click on “CAC ”.
Click on this ico n to open t he “Mobili ty” branch of the t ree.Click on this ico n to open t he “Mobili ty” branch of the t ree.
In order to make changes, click on “Configure”.
Click on “Show Configuration”
to view th e current CAC
configur ation.
Click on “CAC ”.Click on “CAC ”.