Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-28
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.6 Power Up and Provision the BWX 8415 Basestation
7.6 Power Up and Provision the BWX 8415 Basestation
Reference: BWX EMS Alarm Resolution Reference Manual
7.6.1 Prerequisites
• The EMS must be up and IP-reachable from the BS
• The BWG must be running and configured
• The BS must have been already added to and configured in the EMS
• All equipment in the system must be IP-reachable
• If a laptop with a Test EMS is being used (recommended procedure during commissioning), connect
this laptop to the BS via a Telnet session
Note The Telnet session will not be established until after the BS has booted up.
• Make sure the ‘Test’ EMS server is running on a laptop
• Open a terminal emulation session using one of the following programs:
–
Tera Term Pro
–
HyperTerm
–
Other terminal emulation programs
• Verify the serial port settings
Figure 7-37 Serial Port Settings