Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-29
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.6.2 BWX 8415 Basestation Bootup
7.6.2 BWX 8415 Basestation Bootup
7.6.2.1 Power On
Step 1 With the laptop connected to the BS, through the backhaul network and TeraTerm Pro or Hyperterm
running, power up the BS.
Step 2 The system boot sequence starts. When the “Press any key to stop auto-boot...” prompt appears, DO
NOT press any keys. (
Example 7-1).
Example 7-1 System Boot Sequence Begins (NEED NEW BOOT SEQUENCE SCREENSHOTS)
Step 3 When the “Auto-booting (Enter “configure setup)” prompt appears, type the word config before the
countdown reaches zero (
Example 7-2).
Step 4 At the boot prompt, type p and hit <Enter> to see the current value of the boot parameters
(
Example 7-2).
Step 5 At the boot prompt type c and hit <Enter> to configure the boot parameters, one at a time (Example 7-2).
Note Each time you hit <Enter> the next parameter and its current value are displayed and you have the
opportunity to type a new value. When an incorrect parameter appears, type the correct value and hit
<Enter> to continue.
Press any key to stop auto-boot...
0
auto-booting...
boot device : ataa
unit number : 0
processor number : 0
host name : host
file name : core
inet on ethernet (e) : 192.168.1.100:fffff800
inet on backplane (b): 10.0.0.1:fffffffc
host inet (h) : 192.168.1.220
gateway inet (g) : 192.168.1.1
user (u) : ate
ftp password (pw) : ate
flags (f) : 0x8
target name (tn) : nero
startup script (s) : loads/ldlineup
other (o) : mv0
CPLD Firmware Version: 0x18
Attaching to ATA disk device... done.
Loading /ata0a/LOADS/BTSB/core...22257072
Starting at 0x10000...
WHEN YOU SEE THIS PROMPT,
DON’T
PRESS ANY KEY!!!
In a second or two, a "0" will be displayed and the
boot sequence will contine…
But if If you hit any key, a “1” will be displayed, the
boot process will be interrupted, and you will be
taken into the VxWorks shell (you will see the
VxWorks Boot Prompt).
THERE IS NO REASON FOR YOU TO GO INSIDE
THE VxWorks SHELL!!!!!
Ignore all this