Installation Manual Part 4

PRELIMINARY
7-30
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.6.2 BWX 8415 Basestation Bootup
Example 7-2 System Boot Sequence (NEED NEW BOOT SEQUENCE SCREENSHOTS)
Step 6 Enter p to verify(Example 7-3).
Step 7 When all changes have been made, type @ and hit <Enter> to resume the boot process (Example 7-3).
Auto-booting (Enter "config" for setup)... 17config
[Navini Boot]:
[Navini Boot]:
[Navini Boot]: p
date and time : 10/22/2008[14:21]
autoboot countdown : delayed
ems inet : 192.168.1.220
snmp community : public
traffic path : enet
mac address : 00:04:6a:00:3b:cc
ip on enet (active) : 192.168.1.100
ip on enet (standby) : 192.168.1.101
netmask on enet : 255.255.248.0
mgmt vlan id|priority: 1:0 [1-4094]:[0-7]
ip on backplane : 10.0.0.1
gateway on enet : 192.168.1.1
[Navini Boot]:
[Navini Boot]:
[Navini Boot]: c
date and time : 10/22/2008[14:22]
MM/dd/yyyy[hh:mm]
autoboot countdown : delayed [quick|delayed]
ems inet : 192.168.1.220 192.168.2.208
snmp community : public
traffic path : enet
mac address : 00:04:6a:00:3b:cc
ip on enet (active) : 192.168.1.100 192.168.2. 67
ip on enet (standby) : 192.168.1.101
netmask on enet : 255.255.248.0 255.255.255.0
mgmt vlan id|priority: 1:0 [1-4094]:[0-7]
ip on backplane : 10.0.0.1
gateway on enet : 192.168.1.1 192.168.2.1
[Navini Boot]:
 At this prompt, type
"config" before the
autoboot countdown expires
(by default it is set to
"delayed" lasting 20
seconds)
 At the Navini Boot prompt,
type "p" and hit <Enter> to
check the current value of
the parameters
Identify the bootline
parameters that need to be
changed
 At the Navini Boot prompt,
type “c" and hit <Enter> to
change the current value of
the parameters
Change the desired
parameters, one at a time