Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-34
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.6.2 BWX 8415 Basestation Bootup
7.6.2.2 Check for Alarms
To check the EMS CAM for alarms, follow the instructions in Figure 7-38. All alarms must first be
acknowledged, then cleared. Refer to the BWX EMS Alarm Resolution Reference Manual for look-up
descriptions and resolutions for each alarm.
Figure 7-38 Check Alarms
Refer to Figure 7-39 for the Alarm Severity indicators.
1. Select BTS tab, then select one or more BTSs
1. Select BTS tab, then select one or more BTSs
2. Click on the
Alarm Icon to see
the BTS Alarms
2. Click on the
Alarm Icon to see
the BTS Alarms
A few alarms will appear and
will be automatically cleared
during the BTS boot.
Once an alarm is "cleared" and
"acknowledged", it disappears.
If an alarm is not automatically
acknowledged you can
acknowledge it manually to
make it go away.
A few alarms will appear and
will be automatically cleared
during the BTS boot.
Once an alarm is "cleared" and
"acknowledged", it disappears.
If an alarm is not automatically
acknowledged you can
acknowledge it manually to
make it go away.
This is an alternative to viewing
the outstanding BTS alarms by
entering the ShowAlarms
command at the "console"
(terminal emulation) window
This is an alternative to viewing
the outstanding BTS alarms by
entering the ShowAlarms
command at the "console"
(terminal emulation) window
1. Select BTS tab, then select one or more BTSs
1. Select BTS tab, then select one or more BTSs
2. Click on the
Alarm Icon to see
the BTS Alarms
2. Click on the
Alarm Icon to see
the BTS Alarms
A few alarms will appear and
will be automatically cleared
during the BTS boot.
Once an alarm is "cleared" and
"acknowledged", it disappears.
If an alarm is not automatically
acknowledged you can
acknowledge it manually to
make it go away.
A few alarms will appear and
will be automatically cleared
during the BTS boot.
Once an alarm is "cleared" and
"acknowledged", it disappears.
If an alarm is not automatically
acknowledged you can
acknowledge it manually to
make it go away.
This is an alternative to viewing
the outstanding BTS alarms by
entering the ShowAlarms
command at the "console"
(terminal emulation) window
This is an alternative to viewing
the outstanding BTS alarms by
entering the ShowAlarms
command at the "console"
(terminal emulation) window