Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-35
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.6.3 Provision the BWX 8415 Basestation
Figure 7-39 Alarm Severity Indicators
7.6.3 Provision the BWX 8415 Basestation
When all of the basic BS configuration is completed, the BS needs to be provisioned. If the BS is
“provisioned”, then any change to the record immediately affects the BS. If “unprovisioned”, you can
change the record without affecting the BS. Certain actions (like “Calibrate”) require that the BS be
“provisioned”.
The steps to provision the BS are shown in Figure 7-24 through Figure 7-29. Please refer to these figures
as you read the remainder of this section.
Step 1 From the BTS tab, right-click on the BS which is to be provisioned.
Step 2 In the pull-down select Action > Provision to make that record active for the new BS.
Severity indicators
1 – Warning 2 – Minor 3 – Major 4 - Critical