Installation Manual Part 4

Table Of Contents

PRELIMINARY

7-6

BWX 8415 Basestation Installation and Commissioning Guide

OL-19519-01

Chapter 7 Commissioning

7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG)

Figure 7-5 FTP Server Windows Example

Note If upgrading the EMS software from release 6.2.X to release 7.0 or higher, it will be necessary to

manually change the Ftp Server Root Path field in the Config EMS screen to “C:\CiscoEMS\ftp”.

7.1.3.3.2 Alarm Management Configuration

Alarm Management configuration of the EMS server includes setting the Alarm Auto Acknowledgement

(Alarm AutoAck) parameter, setting the Maximum Acknowledgements per hour (Max Ack Per Hour)

parameter, and setting up the Alarm Notification by Email parameters (Mail server IP, Email addresses,

& specifying which alarms will be mailed to which addresses).

7.1.3.3.3 Performance Management Configuration

Performance Management configuration of the EMS server includes setting the Enable Performance

Analyzer (Enable PerfAnalyzer) parameter, setting up the Alarm Notification by Email parameters (Mail

server IP, & Email addresses) and setting up the SS Auto Logging parameters.

7.2 Install Access Services Network Gateway (ASN-GW)

Hardware and Broadband Wireless Gateway (BWG) Software

The BWX 8415 Basestation interfaces a 7600 Series Access Services Network Gateway (ASN-GW)

router (refer to

Figure 7-6). The router must be installed, and then loaded with the WiMAX software

application called Broadband Wireless Gateway (BWG). It is beyond the scope of this document to

provide router installation procedures. For information on installing the Cisco BWG, refer to the

ASN-GW documentation at the following links:

<EMS Install Directory>: C:\CiscoEMS

<Ftp Server Root Path>: C:\CiscoEMS\ftp

<BTS CPE SW Directory>: loads

<BTS CPE SW Ftp User Name>: ems

<BTS CPE SW Ftp Password>: ems

FTP --> Add User --> User Name: ems, Password: ems, Default Directory: C:\CiscoEMS\ftp

FTP

EMS