Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-7
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.3 Add and Configure the BWG to the EMS Server
www.cisco.com > Documentation > Routers > Cisco 7300 Series Routers or Cisco 7600 Series Routers
or
http://www.cisco.com/en/US/products/hw/routers/ps352/tsd_products_support_series_home.html
or
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
or BWG Data Sheet:
http://wwwin.cisco.com/sptg/mscbu/mwg/prods/cmx/pg/bwg/files/BWG-R11-DS.pdf
In section 7.3 are the configuration settings to make the BS and BWG communicate.
Figure 7-6
7600 ASN-GW Routers
7.3 Add and Configure the BWG to the EMS Server
Reference:
• BWX Mobile WiMAX Configuration Guide P/N: OL-16313-02
Please refer to the BWX Mobile WiMAX Configuration Guide for instructions on the configuration of the
BWG. The configuration of the BWG includes the following elements:
The EMS configures in the BWG all information relative to service level agreements (service flows,
packet classifiers, quality of service, user groups, VRFs, etc.) and the definition of AAA services. EMS
initiated BWG configuration is only written into memory. To make configurations non-volatile, they
must be saved with the BWG Action command “Commit to BWG”.
The EMS does not configure Layer 3 information, such as physical and logical interfaces, and routing.
These must be configured manually in the BWG.
7600