User's Guide

Ripwave Modem User Guide Navini Networks, Inc.
22 050503_pv1.1_Ripwave Modem User
Guide_40-00097-00j(4.3)
Installing Navini
Ripwave
Monitor
(NavMon)
Navini’s monitoring software (Navini Ripwave Monitor or Navini
Diagnostics) provides two types of information: signal strength and
quality of the incoming signal. It also can provide information
about the connectivity to the Service Provider’s network. These
displays may be required when troubleshooting Modem problems.
The next few sections will discuss how to install, troubleshoot
with, and uninstall your Navini Ripwave Monitor (NavMon)
software. If your Ripwave Modem has a software release of 4.0 or
greater, you do not have the NavMon. You have the Navini
Diagnostics software. You should refer to the sections that discuss
how to install, troubleshoot with, and uninstall your Navini
Diagnostics software.
Before you install your NavMon software, please note:
 For Windows NT and Windows 2000 you must log into an
account having Administrative privileges in order to install the
Navini Monitor software.
 For Windows 98, and 98SE Operating Systems (OS), the OS
CD may be required to complete this installation. If prompted,
insert the OS CD into the CD-ROM drive and accept the
defaults.
 After the NavMon software is loaded, if you must upgrade your
PC OS, first uninstall NavMon prior to upgrading the OS.
Otherwise, NavMon will not work. See Uninstall instructions
in this Guide.
Note: The screenshots shown in these instructions were taken from
a laptop with Windows 2000. If you have a Windows 98, XP,
or ME operating system, the screens you see may vary from the
screens shown in the instructions.
Step Action Illustration
1. Shut down all programs,
including anti-virus
software programs,
before installing the
Navini Ripwave
Monitor software.
2. Insert the NavMon
Installation CD into the
CD-ROM drive.