IP Phone User Manual

7-12

User Guide for CiscoWorks QoS Policy Manager 4.1.6

OL-23444-01

Chapter 7 Provisioning: Configuring QoS for IP Telephony

Configuring QoS Using the IP Telephony Wizard

If QPM recognizes that the neighboring switch has Layer 3 QoS capabilities, it will trust DSCP from the

Layer 3 switch. If there is no neighboring switch (or if the switch is of unknown type), QPM will

configure QoS for a Layer 2 device.

To select IntraLAN connections:

Step 1 Select the switch interfaces on which to configure QoS for the LAN connections in the network, by

selecting the check boxes next to the appropriate interfaces in the selection table.

For more information about the columns in this table, see IP Telephony Wizard: Select IntraLAN

Connections Page, page B-136.

Step 2 To remove any interfaces that were previously assigned for this voice role:

a. Click the Remove button in the Advanced section of the page.

A page appears, displaying the network elements assigned for the IntraLAN voice role.

For more information about this page, see IP Telephony Wizard: Remove Network Elements Page,

page B-132.

b. Select the interfaces you want to unassign and click Remove.

The page closes.

Step 3 Click Next.

If the Display Configuration Info. check box is selected, the Configuration Info page appears. After

reviewing the assignments summary, click Next.

The voice policy groups and your LAN interfaces assignments will be saved, and the next configuration

step of the wizard appears (Selecting Voice VLAN Connections).