User's Manual

5
Step 4 Align the module connector with the connector on the
back of the access point and click the module into
place.
Figure 2 Installing Module in the Cisco Aironet 3600 Access
Point
Step 5 Screw down the thumb screws on the module.
Note If the screws are not tightened, the module will not be
recognized and may not operate correctly. Make sure
not to over-tighten the screws; they should be only
hand-tightened.
Step 6 Power up the access point. When the access point boots
up, it recognizes the module. No software
configuration is required.
Step 7 If necessary, mount the Cisco Aironet 3600 Series
access point, with the USC 5310 plug-in module
installed, using the universal bracket
(AIR-AP-BRACKET-2).
380756