User's Manual

4. Attach the mount plate to the T-rail clips. Attach the mount plate to the installed T-rail clips

using the 6-32-4” screws through the T-rail mount holes on the mount plate (marked with

a T on the mount plate) as shown. For recessed T-rails, use the included 6-32-7” screws

and rubber spacers. For recessed T-rail case, pre-assemble the spacers and screws to the

mount plate by pushing the screws through the mount plate holes into the rubber spacers.

At this point the plate can be held with one hand while the other hand holds a screwdriver.

Rubber spacers

(Recessed T-rail only)

Flush T-rail: 6-32-4” screws

Recessed T-rail: 6-32-7” screws