User's Manual

7
2.3 Security Features
The MR16 features multiple options for physically securing the access point after installation:
1. Security screw – The accessory kit includes screws that can be used to secure the access point to
the mount plate. Engaging the security screw prevents accidental dislodging and theft.
2. Kensington lock – The access point contains a hard point that allows it to be secured to any nearby
permanent structure using a standard Kensington lock.
2.4 Ethernet Ports
Both MR12 and MR16 feature a Gigabit Ethernet RJ45 port that accepts 802.3af power (labeled
“Eth0, PoE”). This port should be used for uplink to your WAN connection. MR12 also
features an additional Fast Ethernet RJ45 port (labeled Eth1) that can be used to connect additional LAN
devices such as printers and IP phones.
2.5 Power Source Options
The MR16 access point can be powered using either the Meraki AC Adapter or 802.3af PoE Injector (both sold
separately) or a third-party 802.3af PoE switch.
2.6 Factory Reset Button
The Factory Reset Button has two functions. If the button is pressed and immediately released, the MR16 will
reboot but keep its original configuration. If the button is pressed and held for at least five seconds and then
released, the MR16 will reboot and be restored to its original factory settings by deleting all
configuration information stored on the unit.
Signal Strength
One Light: Fair
Four Lights: Strongest
Moving Lights: Searching for Signal
Flashing Lights: Error state. May indicate bad gateway or other routing fault
Radio Power
Off: MR16 is off
Solid Orange: MR16 is booting or trying to find a path to the internet
Solid Green: MR16 is fully operational and connected to the network
Flashing Orange: Firmware is upgrading
Flashing Green: Error state. May indicate bad gateway or other routing fault
Ethernet
Off: No active network connection at the Ethernet port
On: Active network connection at the Ethernet port
Flashing: Error state. May indicate bad gateway or other routing fault
The MR16 may be operated in “Run Dark” mode for additional security and to reduce the visibility of the access
point. In this mode, the LEDs will not be illuminated. This mode may be enabled through Meraki Dashboard.
2.7 UL 2043 Plenum rating*
The MR16 meets the UL 2043 plenum-rating standard. This certifies that the MR16 has adequate fire resistance
and low smoke-emission characteristics to be mounted and operated in a building’s environmental air spaces,
such as above suspended ceilings in an office environment. (*UL 2043 rating applies to MR16 only.)