User's Manual

*
Meraki MX60W Installation Guide
Pre-Deployment Setup | 10
2.4 Installation Instructions
Cables, Power, and Antennas included
• 2VDC Power adapter.
• Cat5e patch cables.
• Dual Band Omni Joint-and-Knuckle Antennas.
2.4.1 Desk
1. Place the MX60 on the desk surface
2. Attach the 3 (included) antennas. Bend them to a right angle so
they all point “up”.
3. Attach network and power cables as needed
2.4.2 Wall (Instructions for Drywall/hollow wall installation)
Material Included in “Wall Mounting hardware”:
• 4 wall anchors.
• 4 wall mounting screws.
Tools needed:
• Phillips screwdriver
• Hammer
• Drill with 1⁄4 inch bit
It is recommended to install the MX60W so the logo is oriented “right
side up”. However the mounting crosses on the base support upside
down or right angle orientations as well.
1. Drill 2 1/4” holes in the wall, spaced 5 1/8” apart
2. Insert included Wall anchors. If you have a wall material other than
drywall, use appropriate anchors for your wall.
3. Screw in included mounting screws. Top when approximately 5-
8mm of screw is showing outside the anchor material.
4. Hang the MX60W on the two mounting screw heads
5. Attach the 3 (included) antennas. Point them away from the body of
the MX60W.
6. Attach network and power cables as needed