User's Manual

White
3 Pre-Install Preparation
You should complete the following steps before going on-site to perform an
installation.
3.1 Configure Your Network in Dashboard
Meraki recommends that you add your MR30H to a network in Dashboard
before mounting it in the field. The following is a brief overview only of the
steps required to add an MR30H to your network. For detailed instructions
about creating, configuring and managing Meraki wireless networks, refer
to the Meraki Cloud Controller Manual
(cisco.meraki.com/support/#documentation).
1. Login to http://dashboard.meraki.com. If this is your first time, create a
new account.
2. Find the network to which you plan to add your nodes or create a new
network.
3. Add your nodes to your network. You will need your Meraki order number
(found on your invoice if you ordered directly from Meraki) or the
serial number of each node, which looks like Qxxx-xxxx-xxxx, and is
found on the bottom of the unit.
4. Finally, go to the map / floor plan view and place each node on the map
by clicking and dragging it to the location where you plan to mount it.
You can always modify the location later.
3.2 Check and Upgrade Firmware
To ensure your MR30H performs optimally immediately following
installation, Meraki recommends that you facilitate a firmware upgrade prior
to mounting your MR30H.
1. Attach your MR30H to power and a wired Internet connection.
2. The MR30H will turn on and the LED will glow solid orange. If the unit
does not require a firmware upgrade, the LED will turn solid white