User's Manual
Table Of Contents
- Introduction to Video Conferencing
- Video Calls
- Place Call From Contact List
- Edit a Contacts List Entry, then Place the Call
- Place Call Using Name, Number or IP-Address
- Receive Calls — When not In a Call Already
- Receive Calls While in Another Call
- Disconnect Yourself From Call
- Put Call on Hold and Resume a Call on Hold
- Transfer an Ongoing Call
- Activate Do Not Disturb
- Automated Forwarding of All Calls
- View Keypad While in a Call
- Add Additional Participants to Existing Call
- Disconnect a Participant From a Conference
- Intelligent Proximity
- Content Sharing
- Scheduled Meetings
- Contacts
- Camera
- Settings
D1534506 Cisco TelePresence User Guide
Systems using Touch10
Produced: April 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
18
Place the call, in the usual way.
Locate whom to call, in the usual way.
Your video system network may
be equipped with the capability to
initiate a video conference with
several participants.
The maximum number of
participants supported by your
video system will depend on
system conguration and the video
infrastructure. If in doubt, contact
your video support team.
If you want to initiate a video
conference, you must call each
participant one by one.
If you are the one who initiated
the conference you will be able to
terminate the entire conference.
The other participants may only
disconnect themselves from the
conference.
Add Additional Participants to Existing Call
Video Calls
About Video
Conferences
1 2
3
Assume that you already are in a call. This
call may have been initiated by you or by
someone else (someone called you). Tap
Add.
4
This new call will now be added to the
existing and
you have now established a
conference.
You may repeat this procedure to
the extent permitted by your video
infrastructure.