User's Manual
Table Of Contents
- Introduction to Video Conferencing
- Video Calls
- Place Call From Contact List
- Edit a Contacts List Entry, then Place the Call
- Place Call Using Name, Number or IP-Address
- Receive Calls — When not In a Call Already
- Receive Calls While in Another Call
- Disconnect Yourself From Call
- Put Call on Hold and Resume a Call on Hold
- Transfer an Ongoing Call
- Activate Do Not Disturb
- Automated Forwarding of All Calls
- View Keypad While in a Call
- Add Additional Participants to Existing Call
- Disconnect a Participant From a Conference
- Intelligent Proximity
- Content Sharing
- Scheduled Meetings
- Contacts
- Camera
- Settings
D1534506 Cisco TelePresence User Guide
Systems using Touch10
Produced: April 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
23
Your video system supports the
ability to show presentations in a
video call or video conference.
If your source device has been
Intelligent Proximity enabled, just
switch on Proximity on your device,
let your device pair with the video
system and you will be able to share
content right away.
Note that you may change the layout
of the screen during presentations,
see the following pages for more on
this.
Sharing Content In a Call
Content Sharing
About Content Sharing
1 2
3
Connect the source to the video system
with a suitable cable, make sure it has been
switched on and tap Share.
4
To discontinue sharing content with the
remote participants, tap Stop sharing.
To discontinue the preview, tap Stop preview.
To share content with the remote participants, tap
Share in call.
Tap Local preview to view the content to
be shared on your own video system only.
This will not be shared with the remote
participants.
Tap the X in the upper right corner, as
shown, to return to the previous display.