User's Manual
Table Of Contents
- Introduction to Video Conferencing
- Video Calls
- Place Call From Contact List
- Edit a Contacts List Entry, then Place the Call
- Place Call Using Name, Number or IP-Address
- Receive Calls — When not In a Call Already
- Receive Calls While in Another Call
- Disconnect Yourself From Call
- Put Call on Hold and Resume a Call on Hold
- Transfer an Ongoing Call
- Activate Do Not Disturb
- Automated Forwarding of All Calls
- View Keypad While in a Call
- Add Additional Participants to Existing Call
- Disconnect a Participant From a Conference
- Intelligent Proximity
- Content Sharing
- Scheduled Meetings
- Contacts
- Camera
- Settings
D1534506 Cisco TelePresence User Guide
Systems using Touch10
Produced: April 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
35
Camera
Preset editing is all about taking an
existing preset, altering it and then
saving it under the same name.
If you want to change the name,
we recommend that you delete the
preset and create a new one with
the preferred name.
About Editing Presets
Edit Camera Position Preset
Tap the little arrowhead of the preset to
be edited.
Tap Camera to access the Camera menu.
Tap the preset to be edited. Selfview
will be activated automatically.
Adjust Pan, Tilt and Zoom, as required.
Tap anywhere outside the menu when
you’re done.
Tap Update to current position to
put your changes into eect.
Alternatively, tap Use as default
(camera) position.
To delete an existing preset tap
Remove.
1 2 3
4 5 6