User's Manual
Table Of Contents
- Introduction to Video Conferencing
- Video Calls
- Place Call From Contact List
- Edit a Contacts List Entry, then Place the Call
- Place Call Using Name, Number or IP-Address
- Receive Calls — When not In a Call Already
- Receive Calls While in Another Call
- Disconnect Yourself From Call
- Put Call on Hold and Resume a Call on Hold
- Transfer an Ongoing Call
- Activate Do Not Disturb
- Automated Forwarding of All Calls
- View Keypad While in a Call
- Add Additional Participants to Existing Call
- Disconnect a Participant From a Conference
- Intelligent Proximity
- Content Sharing
- Scheduled Meetings
- Contacts
- Camera
- Settings
D1534506 Cisco TelePresence User Guide
Systems using Touch10
Produced: April 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
37
Camera
Systems with speaker tracking
may include the Presenter preset.
This preset must have been
implemented by your video support
team to work.
PresenterTrack enables the camera
to zoom in and track a presenter
who is moving about the stage
presenting.
Once the presenter leaves the stage
the tracking is brought to a hault.
The procedure for setting this up
and the products supporting this
feature can be found in the CE9.0
Administrator Guide for our room
systems and codecs.
About Presenter Tracking
Presenter Track
To enable Speaker Tracking, tap Camera, in the
upper right corner.
Systems with Speaker Track enabled will
have this as a camera preset, as shown.
1 2
3
Tap anywhere outside the menu to exit.
To deactivate Presenter Track, press the preset
again.