User's Manual
Table Of Contents
- Introduction to Video Conferencing
- Video Calls
- Place Call From Contact List
- Edit a Contacts List Entry, then Place the Call
- Place Call Using Name, Number or IP-Address
- Receive Calls — When not In a Call Already
- Receive Calls While in Another Call
- Disconnect Yourself From Call
- Put Call on Hold and Resume a Call on Hold
- Transfer an Ongoing Call
- Activate Do Not Disturb
- Automated Forwarding of All Calls
- View Keypad While in a Call
- Add Additional Participants to Existing Call
- Disconnect a Participant From a Conference
- Intelligent Proximity
- Content Sharing
- Scheduled Meetings
- Contacts
- Camera
- Settings
D1534506 Cisco TelePresence User Guide
Systems using Touch10
Produced: April 2017 for CE9.0
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
9
You may call someone who is not
listed in your list of contacts by
keying in their name, address or
number using the virtual keyboard of
the Touch pad.
Anyone you have previously called
will appear in the Recents list (until
you clear that list) and you may then
transfer any of them to your list of
Favorites. This is described in the
section Contacts.
Sometimes you may be urged to
enter numbers during a call, typically
to reach extensions or to provide a
pin code.
Tap Touch Tones (this button
appears as soon as the call is
placed) to invoke the keypad
needed for this.
Place Call Using Name, Number or IP-Address
Video Calls
About Placing Calls
Tap the Call button.
Tap the Search or Dial eld. This will invoke
the keyboard
When you have typed or located whom to call,
tap either of the green Call buttons to place
the call.
1 2
3 4
Key in a name, number or address. Possible
matches and/or suggestions will appear as you
type. If the correct match appears in the list tap
that match, otherwise keep typing.










