User's Manual

16
4. Plug the Ethernet cable into the PoE+Eth0 port of the Meraki MR58.
a. Connect the cable to the port on the MR58.
b. Screw the gland body into the threaded hole of the port. Use an adjustable
wrench to make sure the gland body is fully seated in the hole.
c. Insert the split ring gasket into the gland body.
d. Screw the cap tightly onto the gland. You may need a wrench to fully
tighten the cap, but take care not to damage the cable in the process.
Optional: Make the MR58 a gateway
1. Connect an active internet connection to the “In” port of the PoE injector.
Aim Antennas
If you are using directional antennas, aim them appropriately to ensure optimal
performance for your specific network topography.
Test Your Network
Confirm that you have good signal strength throughout your coverage area.
You can use the signal strength meter on a laptop.
Troubleshooting
See the Meraki knowledge base at http://meraki.com/help/kb for additional information
and troubleshooting tips.