User's Manual

FCC and Other Disclosures

US – Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

· Consult the dealer or an experienced radio/TV technician for help.

Any changes or modiﬁcations not expressly approved by Meraki, Inc. could void

the user’s authority to operate this equipment.

EU – EN 55 022 Declaration of Conformance

This equipment is shielded against the generation of radio interference in accordance

with the application of Council Directive 89/336/EEC, Article 4a. Conformity is

declared by the application of EN 55 022 Class B (CISPR 22).

For more information,

visit meraki.com/oursolution/hardware/MR58/meraki_MR58_reg.pdf