User's Manual

7
Pre-Site Preparation
You should complete the following steps before going on-site to perform the installation.
RecommendedRequired
Straight-slot
screwdriver
Phillips
screwdriver
9/16”(13mm)
wrenches
Adjustable wrench
Rubber mallet
Drill with appropriate bits
for mounting wall anchors
(if mounting to a wall)
Power screwdriver with 5/16”
(8 mm) nut driver, Phillips & flat heads
x 2
Tin snips
(if mounting with hose clamps)
Collect Additional Hardware for Installation
Required
Network cables with RJ45 connectors long enough for your particular
mounting location
Connection to the internet (if you are setting up your MR58 as a gateway
to the internet)
Appropriately sized metal straps (if mounting to a pole larger than 3.0”
in diameter)
Specialized mounting hardware if mounting to surface other than wood,
stucco or stone
Recommended
Laptop with wireless to verify setup
Collect Tools
You will need the following tools to perform your installation: