Network Router User Manual

A-53
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
NRP Internal PVC Profile
CNX Type [c4_type]
Specify the connection type. This attribute is used to determine what
function the internal PVC will have. An NRP/NRP2 internal PVC can
serve several roles. It can be a subscriber downlink involved in binding
a subscriber stream to a tunnel, an ingress tunnel for multihop PPP
aggregation, a service uplink with tunnel support, or a termination
point for PPP sessions (PPPoA or PPPoE traffic) to be routed as IP
packets to their destination.
W
Enum (11)
"subscriber"
"service"
"multihop_in"
"idsl_sub" "pppip"
"other"
Service Name [c4_servicename]
This is the service name key that associates a subscriber with a tunnel.
This attribute is required if static binding is configured.
W
Text (32)
Sub-interface Type [c4_subiftype]
Specify the type of sub-interface that this internal PVC will use.
C
Enum (14)
"multipoint"
"tag-switching"
"point-to-point"
Bridge Group [c4_bgroup]
Indicates a bridge group. A value of 0 indicates no bridge group for this
subinterface.
R
Numb (10)
Range=0-214748364
7
0
Circuit Type [ratype]
This is the circuit type. It can be either a virtual circuit (VP) or virtual
path (VP).
C
Text (2) "VC"
PVC mapping on IP (only for service CNX)
Upper Layer Protocol [c4_protocol]
This is the upper layer protocol for the PVC.
C
Enum (14)
"ip_broadcast"
"ip_nobroadcast"
"inarp" "none"
VC-Class Attributes
QoS Class [c4_qos]
Specify the QoS class.
W
Enum (9) "CBR"
"UBR" "UBR+"
"ABR" "rt_VBR.1"
"rt_VBR"
"nrt_VBR"
"nrt_VBR.1"
"Other"
Table A-26 NRP Internal PVC Profile (continued)
Attributes Acceptable Values Default Values