Network Router User Manual

A-54
Cisco 6400 Equipment Module Configuration Guide
OL-1812-01
Appendix A Attribute Reference
NRP Internal PVC Profile
PCR [c4_pcr]
PCR is the maximum allowed cell transmission rate. It defines the
shortest time period between cells and provides the highest guarantee
that network performance objectives (based on cell loss ratio) will be
met.
W
Numb (10)
Range=0-214748364
7
365566
MCR [c4_mcr]
MCR is the minimum cell rate, which is the minimum allocated
bandwidth for a connection.
W
Numb (10)
Range=0-214748364
7
0
NRP->NSP Bandwidth [c4_az_bandwidth]
The bandwidth from the NRP/NRP2 to the NSP.
C
Numb (10)
Range=0-214748364
7
0
NSP->NRP Bandwidth [c4_za_bandwidth]
The bandwidth from the NSP to the NRP/NRP2.
C
Numb (10)
Range=0-214748364
7
0
Encapsulation [c4_encapsulation]
Specify the ATM adaptation layer (aal) and the encapsulation type.
W
Enum (12)
"aal5ciscoppp"
"aal5autoppp"
"aal5snap"
"aal5mux"
Virtual Template Attributes
Authentication [c4_authenticate]
This is the authentication type. When none is selected, no
authentication will be performed. PAP will enable Password
Authentication Protocol to authenticate the tunnel. CHAP will enable
Challenge Handshake Authentication Protocol to authenticate the
tunnel.
W
Text (80)
Unnumbered IP Address in VT [c4_vt_ipaddr]
Specify the interface that you want IP enabled on without assigning a
specific IP address (i.e. fastethernet 0/0/0). This attribute is used when
configuring a virtual template to assign PPP features to a PVC.
W
Text (40)
Table A-26 NRP Internal PVC Profile (continued)
Attributes Acceptable Values Default Values