User's Manual

2-101
Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
OL-7310-01
Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module
webvpn gateway
webvpn gateway
To enter the gateway submode and define the virtual gateway, use the webvpn gateway command. Use
the no form of this command to remove any commands that you have entered in the WebVPN
subcommand mode from the configuration.
webvpn gateway gateway-name
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration
Command History
Usage Guidelines The gateway-name argument is case-sensitive.
After you enter the webvpn gateway command, the prompt changes to the following:
webvpn(config-webvpn-gateway)#
After you enter the gateway submode, there are commands available to configure the virtual gateway
services. Table 2-9 lists the virtual gateway submode commands.
gateway-name Name of the virtual gateway service.
Release Modification
WebVPN Module
Release 1.1
Support for this command was introduced on the Catalyst 6500 series
switches.
Table 2-9 Virtual Gateway Submode Commands
Command Purpose and Guidelines Defaults
exit Exits from the gateway configuration mode and returns to
the global configuration mode.
hostname hostname Specifies the name of the gateway that is used in the URL
and cookie mangling process. In the load-balancing
configuration, the hostname specified here is the virtual
gateway IP address configured on the LB device.
http-redirect [port port] Specifies that the HTTP port is open and that any HTTP
connections to the virtual gateway is directed to use secure
HTTP (HTTPS).
port port—(Optional) Specifies the port number to be
redirected; valid values are from 1 to 65535.
port is 80.
inservice
no inservice
Enables the WebVPN gateway. Use the no form of this
command to disable the WebVPN gateway.