User's Manual

2-39
Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
OL-7310-01
Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module
policy group
functions{file-access|
file-browse |
file-entry|
svc-enabled|
svc-required}
Specifies the file function as follows:
Note You must enable file-access before you can enable
file-browse or file-entry.
• file-access—Allows you to access the file servers that are listed
on the home page.
• file-browse—Allows you to browse file servers. When you
disable this option, you are denied entry to a file server.
• file-entry—Allows you to alter a file in a file server.
• svc-enabled—Allows the user of the group to use tunnel mode.
If the SVC fails to install on the end user's PC, the end user can
continue to use clientless mode or thin-client mode.
• svc-required—Tunnel mode is required. If the SVC fails to
install on the end user’s PC, the end user cannot use other
modes.
All values are disabled.
hide-url-bar Disables the URL bar on the portal page.
Note This command applies only to clientless mode.
nbns-list name Specifies the NBNS list for CIFS as defined in the context
configuration.
Supported only with Windows 2000 servers and Linux/UNIX.
Note This command applies only to clientless mode.
no Negates a command or set its defaults.
port-forward name Specifies the port-forward list as defined in the context
configuration. Entering the command again overrides the previous
setting. The default is to have no list specified,
Note This command applies only to thin-client mode.
No list specified, and port
forwarding is disabled.
timeout {idle |
session} seconds
Specifies the end-user idle timeout value and maximum session
timeout value for the user or group.
idle seconds—Specifies the end-user inactivity. Valid values for
idle timeout are from 0 (disabled) to 3600 seconds.
session seconds—Specifies the total session time, regardless of
activity. Valid values for session timeout are from 1 to 1209600
seconds.
idle seconds—2100
seconds (35 minutes)
session seconds—43200
seconds (12 hours)
svc Specifies the tunnel configuration; see the svc command for
additional information.
url-list name Specifies the URL list as defined in the context configuration.
Entering the command again overrides the previous setting.
Note This command applies only to clientless mode.
No list is specified.
Table 2-3 Group-policy Commands
Command Purpose and Guidelines Defaults