User's Manual

2-41
Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
OL-7310-01
Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module
port-forward
port-forward
To enter the port-forwarding submode and configure port-forwarding entries, use the port-forward
command. Use the no form of this command to remove the given list from the configuration.
port-forward listname
no port-forward listname
Syntax Description
Defaults This command has no default settings.
Command Modes WebVPN context submode
Command History
Usage Guidelines The listname argument is case-sensitive and can be a maximum of 64 characters.
After you enter the port-forward command, the prompt changes to the following:
webvpn(config-webvpn-port-fwd)#
After you enter the port-forward submode, there are commands available to configure the
port-forwarding services. Table 2-4 lists the port-forwarding submode commands.
listname Name for list of forwarded ports.
Release Modification
WebVPN Module
Release 1.1
Support for this command was introduced on the Catalyst 6500 series
switches.
Table 2-4 Port-Forwarding Submode Commands
Command Purpose and Guidelines Defaults
default local-port
port-number
Specifies the default local port; valid values are from 1 to 65535.
exit Exits WebVPN port-fwd submode and returns to WebVPN context
submode.