User's Manual

2-51

Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1

OL-7310-01

Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module

show webvpn platform context

To display information on WebVPN context, use the show webvpn platform context command.

show webvpn platform context name [module module]

Syntax Description

Defaults This command has no default settings.

Command Modes EXEC

Command History

Examples This example shows how to display status information about the specified context:

webvpn# show webvpn platform context tunnel

Certificate authentication type: peer certificate is always accepted

Admin Status: up

Operation Status: up

webvpn#

This example shows how to display all module status information about the specified context:

webvpn# show webvpn platform context tunnel module all

FDU Service Entry

Service ID : 8 Protocol : 0

Virtual IP : 0.0.0.0 Virtual port : 0

HTTP-redirect: 0

Hash Index : 0 Conn Count : 0

Bound ID : 0 State : DOWN

Service ID 8

IP address : 116.117.110.110 Port : 0

MSS : 1460

SYN timeout (s): 75

Idle timeout (s) : 600

FIN wait timeout (s) : 75

Reassembly timeout (s) : 60

name Name of the context.

module module Valid values for module are as follows:

all—all CPUs

fdu—FDU CPU

ssl1—SSL1 CPU

tcp1—TCP1 CPU

tcp2—TCP2 CPU

Release Modification

WebVPN Module

Release 1.1

Support for this command was introduced on the Catalyst 6500 series

switches.