User's Manual

2-73
Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
OL-7310-01
Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module
svc
svc
To configure the tunnel capabilities for a group-policy context, use the svc command. Use the no form
of this command to remove any of the svc commands that you have entered.
svc command
Syntax Description
Defaults See Table 2-5 for the default settings.
Command Modes WebVPN group context submode
Command History
Usage Guidelines The prompt for the svc command is the same as the group-policy prompt.
Table 2-5 lists the commands available to configure tunnel-mode capability for a group context.
command Specifies the configuration command; see Table 2-5 for a list of available
commands.
Release Modification
WebVPN Module
Release 1.1
Support for this command was introduced on the Catalyst 6500 series
switches.
Table 2-5 Tunnel-Mode Configuration Commands
Command Purpose and Guidelines Default
address-pool address-pool-name Assigns addresses from the pool to the remote users.
default-domain default-domain-name Specifies the default domain to be used for the user/group,
if tunnel-mode WebVPN is enabled for the user/group.
dns-server (primary | secondary}
ip-address
Specifies the primary and secondary DNS servers for web
browsing. After the SSL VPN client (SVC) is installed, the
active web browser is deactivated and a new browser is
launched. The DNS server information specified here is for
the newly launched browser. Once the connection is closed,
the previous DNS settings are reapplied.