User Manual

Using a Handset, Headset, and Speakerphone
Cisco Unified Wireless IP Phone 7921G for Cisco Unified CallManager 4.1, 4.2, 5.0 and Later 43
FINAL REVIEW - Cisco Confidential
Using a Handset, Headset, and Speakerphone
You can use your phone as a mobile handset, a speakerphone, with a headset, or with the
speakerphone in the desk top charger.
If you want to... Then...
Use the handset Press the (green button); press (red button) to hang up.
Use a headset Plug the headset connector into the headset port . The icon
displays on the phone status line. Place and answer calls as usual.
If you use AutoAnswer, see Using AutoAnswer, page 44 for
exceptions.
You can use the headset with all the
controls on your phone, including and .
Use the speaker mode Press before placing a call or during a call to activate speaker
mode. The icon displays when the speaker is active.
Note
Speaker mode remains active for future calls until toggled off.
Switch to the speaker (from the
handset) during a call
Press and displays.
Press to toggle back to the handset.
Switch to the desk top charger
speakerphone
1. Place the wireless IP phone in the desk top charger cradle.
“AC connected!” displays on the screen.
2. Press down on the top of the phone.
“Docking connected!” displays on the screen and the desk top
charger speaker and microphone are now connected.
3. Place and receive calls.
Use all the buttons on your phone, including and .
Note
The internal single-direction microphone is located on the
lower left side of the phone (two small holes). For best results,
face the desk top charger when using the speakerphone.