User Manual

44 OL-10806-01
FINAL REVIEW - Cisco Confidential
Obtaining a Headset
Your phone supports headset jack types with a 2.5 mm 3-band/ 4 connector. For information about
purchasing headsets, see Headset Information, page 12.
Using AutoAnswer
You might use AutoAnswer if you receive a high volume of incoming calls or handle calls on behalf of
others. Your system administrator configures AutoAnswer to work with either your speaker mode or
headset.
Switch to the handset from the
desk top charger speakerphone
1. Tip the top of the phone forward about 30 degrees, then pick
up the phone.
2. The desk top charger speaker and microphone disconnect and
the call is now active on the phone.
Note
You cannot turn off the desk top speaker by using the
button.
Adjust the volume level for a
call
During a call, press to adjust the volume for the handset,
speaker, or headset
depending on which mode is in use.
Note
The new volume level is preserved for future calls after
powering off the phone.
If you... Then...
Use AutoAnswer with a
headset
Keep headset mode active by ensuring the headset is plugged into the
phone, even when not on a call.
If your phone is set up to use AutoAnswer in headset mode, calls are
answered automatically only if the icon is in the phone status line.
Otherwise, calls ring normally and you must manually answer them.
Use AutoAnswer with the
desktop charger speaker
Keep the handset in the desktop charger cradle so the speaker is active.
If your phone is set up to use AutoAnswer in speaker mode, calls are
answered automatically using the desktop charger speaker.
Note
You cannot turn off the desktop charger speaker. You must remove
the phone from the cradle to disable the desktop charger speaker.
If you want to... Then...