User Manual
Table Of Contents
- Regulatory Compliance and Safety Information for Cisco Unified IP Phones
- Contents
- Translated Safety Warnings
- Statement 1071—Warning Definition
- Statement 19—TN Power Warning
- Statement 331—Power Supply Installation Warning
- Statement 353—This Product Must be Connected
- Statement 378—Read Wall-Mounting Instructions Before Installation
- Statement 1001—Work During Lightning Activity
- Statement 1004—Installation Instructions
- Statement 1005—Circuit Breaker
- Statement 1015—Battery Handling
- Statement 1019—Main Disconnecting Device
- Statement 1021—SELV Circuit
- Statement 1030—Equipment Installation
- Statement 1040—Product Disposal
- Statement 1072—Shock Hazard from Interconnections
- Statement 1074—Comply with Local and National Electrical Codes
- NOM 121 for Mexico for Cisco Unified IP Phones 9900, 8900, and 8831
- Japanese Electric Appliance and Radio Laws
- Battery Safety Notices
- Cell Phone Interference Caution
- Using External Devices with Your Cisco Unified IP Phone
- European Directives
- Compliance and Safety Information
- Regulatory Compliance
- DGT Warning Statement for Cisco Unified IP Phones 9951 and 9971
- FCC Safety Compliance Statement
- Statement 2002—Declaration of Conformity with Regard to the Directives 2006/95/EC and 2004/108/EC
- Statement 2018—Class B Notice for FCC
- Statement 2022—Class B Notice for Canada
- Canadian Compliance for Cisco Unified IP Phone 9900, 8900, and 8831
- RF Exposure Statement
- Statement 295—Class B Warning for Korea
- Statement 157—VCCI Compliance for Class B Equipment
- Statement 355—Telephone Receivers Produce a Magnetic Field
- Compliance Statement for Brazil
- Obtaining Documentation and Submitting a Service Request
32
Regulatory Compliance and Safety Information for Cisco Unified IP Phones
Statement 6003—Taiwan Battery
Cell Phone Interference Caution
Caution Using a cell, mobile, or GSM phone, or two-way radio in close proximity to a Cisco Unified IP Phone
might cause interference. For more information, refer to the manufacturer's documentation of the
interfering device.
Using External Devices with Your Cisco Unified IP Phone
The following information applies when you use external devices with Cisco Unified IP Phones:
Cisco recommends the use of good quality external devices (speakers, microphones, and headsets) that
are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices such as mobile phones or
two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one
or more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
Eesti
[Estonian]:
ELi akude ja elektroonikaromude direktiivid
Teie Cisco toode võib sisaldada kasutaja vahetatavat akut või püsivalt kinnitatud akut (lisateavet leiate
kasutusjuhendist). Tooteohutuse ning andmeterviklikkuse huvides peaks püsivalt kinnitatud aku
eemaldama või seda vahetama vaid professionaalne hooldustehnik või jäätmekäitleja. Kui toode peaks
tõrkuma püsivalt kinnitatud aku rikke tõttu, võtke palun ühendust Cisco või volitatud hoolduspunktiga.
Kui leiate Cisco tootelt, akult või pakendilt selle sümboli, tähendab see, et vastavat toodet ja/või akut ei
tohi kõrvaldada koos olmejäätmetega.
Kui seadme ja/või akude tööiga lõpeb, ei tohi neid jäätmeid kõrvaldada koos olmejäätmetega – jäätmete
kõrvaldamisel peate kindlasti järgima kõiki kohalikke õigusnorme. Vanade seadmete ja akude
nõuetekohane kõrvaldamine aitab vähendada potentsiaalset ohtu keskkonnale ning inimeste tervisele.
Palun pöörduge lähimasse jäätmekäitluspunkti või toote edasimüüja poole.
廢電池請回收