User's Guide
Cisco Explorer 9800 Multi-Screen
Gateway Series
Models: 9825HDC, 9835HDC, 9842HDC,
9845HDC, 9855HDC, 9862HDC, 9865HDC,
9845HD, 9865HD
Manufactured by:
Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 770 236-1077
Provide Ventilation and Select a
Location
• Remove all packaging material before applying
power to the product.
• Do not place this apparatus on a bed, sofa, rug,
or similar surface.
• Do not place this apparatus on an unstable
surface.
• Do not install this apparatus in an enclosure,
such as a bookcase or rack, unless the
installation provides proper ventilation.
• Do not place entertainment devices (such as
VCRs or DVDs), lamps, books, vases with liquids,
or other objects on top of this product.
• Do not block ventilation openings.
Operating Environment
The gateway is designed for operation indoors
with a temperature range from 32° to 104° F (0°
to 40°C). Each gateway should have adequate
spacing on all sides so that the cooling air vents
on the chassis are not blocked.
Protect from Exposure to Moisture
and Foreign Objects
WARNING: Avoid electric shock and
re hazard! Do not expose this product
to dripping or splashing liquids, rain, or
moisture. Objects lled with liquids, such
as vases, should not be placed on this
apparatus.
WARNING: Avoid electric shock and
re hazard! Unplug this product before
cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/
static cleaning device (dust remover) to
clean this product.
WARNING: Avoid electric shock and
re hazard! Never push objects through the
openings in this product. Foreign objects
can cause electrical shorts that can result in
electric shock or re.
Service Warnings
WARNING: Avoid electric shock! Do
not open the cover of this product. Opening
or removing the cover may expose you to
dangerous voltages. If you open the cover,
your warranty will be void. This product
contains no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this
product, the service technician must perform
safety checks to determine that this product is in
proper operating condition.
Protect the Product When Moving It
Always disconnect the power source when
moving the apparatus or connecting or
disconnecting cables.
20110316_IP Gateway_Safety
United States FCC Compliance
This device has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against such interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy.
If not installed and used in accordance with the
instructions, it may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit di erent from that to which the receiver
is connected.
• Consult the service provider or an experienced
radio/television technician for help.
Any changes or modi cations not expressly
approved by Cisco Systems, Inc., could void the
user’s authority to operate the equipment.
The information shown in the FCC Declaration
of Conformity paragraph below is a requirement
of the FCC and is intended to supply you with
information regarding the FCC approval of
this device. The phone numbers listed are for
FCC-related questions only and not intended for
questions regarding the connection or operation
for this device. Please contact your service
provider for any questions you may have regarding
the operation or installation of this device.