User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
•
Three LEDs (System, Management, and Network/Link status)
The LEDs may be turned off in some chassis models using the Cisco IOS CLI.Note
•
Wi-Fi interface
•
Zero Touch Provisioning (ZTP)
•
Fanless passively-cooled design
•
DC and AC input options
•
IP-65 compliant, sealed enclosure designed for outdoor deployment
•
Mechanical mounting options to enable mounting on Alcatel Lucent (ALU) bracket, side walls, lamp
posts, telephone poles, and cabinets.
The Cisco ASR 901S Series Aggregation Services Router has the following operational views:
•
Front View
•
Back View
•
Top and Bottom Views
Cisco ASR 901S Series Aggregation Services Router: Front View
The Cisco ASR 901S Series Aggregation Services Router front view has two distinct two sections:
Upper Section
This section has a door that is fixed and sealed. It cannot be opened at the outside plant (OSP). This section
houses the electrical circuitry of the router.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
2 OL-29732-01
Introduction
Cisco ASR 901S Series Aggregation Services Router: Front View
REVIEW DRAFT - CISCO CONFIDENTIAL