User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
The following figure illustrates the front view of the router.
Figure 1: Cisco ASR 901S Series Aggregation Services Router
—
Front View
Upper section2Lower section (detachable, houses the cable
bay)
1
Lower Section
This section of the router has a door that can be opened at the OSP. It houses the cable bay and provides access
to the port interfaces and enables the ports to be serviced (like changing the optical modules, cables, and so
on), when required.
Cable Bay—The cable bay is used to route and fix the cables to the bottom panel of the router and connect
power. The FD chassis model has an onboard DC-input and the FA chassis model contains a AC power supply
unit (PSU) that is housed on the right side, inside the cable bay.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 3
Introduction
Cisco ASR 901S Series Aggregation Services Router: Front View
REVIEW DRAFT - CISCO CONFIDENTIAL