User's Manual

CHAPTER 2
Preparing to Install the Router
This chapter guides you through the process of preparing for your Cisco ASR 901S Series Aggregation
Services Router installation. It contains safety information and warnings, site preparation details and
instructions on unpacking the router. It contains the following sections:
•
Safety Guidelines, page 13
•
Safety Warnings, page 16
•
Prerequisites, page 16
•
Site Planning , page 17
•
Unpacking the Router, page 19
Safety Guidelines
Before you begin installing the Cisco ASR 901S Aggregation Services Router, review the safety guidelines
provided in the
Safety Precautions, on page 9 and General Safety Information for Mounting, on page 24
to avoid injuries or damaging the equipment.
For safety and compliance information, see Table 9 in Product Specifications, on page 72.
In addition, before replacing, configuring, or maintaining the router, review the safety warnings listed in the
document Cisco Regulatory Compliance and Safety Information for Cisco ASR 901S Series Aggregation
Services Router.
Safety with Equipment
To ensure your safety and protect the equipment, follow these guidelines. However, these guidelines may not
cover all potentially hazardous situations you may encounter during system installation, so be alert.
Before connecting the system to the power source, read the installation instructions. Statement 1004Warning
•
Before moving the system, always disconnect all the power cords and interface cables.
•
Never assume that power is disconnected from a circuit; always check.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 13