User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Safety Warnings
This section contains important safety warnings for the installation and use of the router.
Translated versions of all safety warnings are available in the safety warnings document that shipped with
your router, and which is available on Cisco.com.
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
Warning
Installation of the equipment must comply with local and national electric codes. Statement 1074Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Class 1 laser product. Statement 1008Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of 181.4°F (83°C). Statement 1047
Warning
Prerequisites
Before installing the Cisco ASR 901S Series Aggregation Services Router, it is important to prepare for
installation by :
•
Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOPs).
•
Unpacking and inspecting the Cisco ASR 901S Series Aggregation Services Router.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
16 OL-29732-01
Preparing to Install the Router
Safety Warnings
REVIEW DRAFT - CISCO CONFIDENTIAL