User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
ASCII terminal (for local configuration) or modem
(for remote configuration)
12
Signal distance limits verified13
Start-up sequence steps completed14
Initial operation verified15
Software image verified16
Unpacking the Router
Procedure
Step 1
Open the shipping container and carefully remove the contents.
When you unpack the router, do not remove the foam blocks attached to antennas and antenna
connectors. The foam protects the antennas and connectors during installation.
Tip
Step 2
Return all packing material to the shipping container, and save it.
Do not discard the packaging materials used in shipping your Cisco ASR 901S Series Aggregation
Services Router. You will need the packaging materials in the future if you move or ship the router.
Note
Step 3
Ensure that all items listed in
Router Package Contents, on page 19 are included in the shipment. If any item
is damaged or missing, notify your authorized Cisco sales representative.
Router Package Contents
Your router kit contains the items listed in the following table:
DescriptionItemQty.
Cisco ASR 901S Series Aggregation Services RouterRouter1
For details about the chassis models, see
Components and Options,
on page 71
For DC routers:Accessory kit1
•
Two-hole lug, 6-AWG ground wire, number10 blue stud (part
number: 32-0619-01)
•
Four pan-head Phillips grounding lug screws used to attach the
lug to the router (part number: 48-0501-01)
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 19
Preparing to Install the Router
Unpacking the Router
REVIEW DRAFT - CISCO CONFIDENTIAL