User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it
can come into contact with such circuits. When installing the antenna, take extreme care not to come into
contact with such circuits, as they may cause serious injury or death. For proper installation and grounding
of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical
Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Warning
Contents of the Mounting Kits
This section describes the contents of the mounting kits available for the router and when you should use each
kit.
Pole Mount Kit
Use the Cisco pole mount kit to install the pole clamp bracket onto any pole or streetlight. The kit supports
poles that meet the following criteria:
•
Size: 2 to 16 inch diameter poles
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 25
Installing the Router
Contents of the Mounting Kits
REVIEW DRAFT - CISCO CONFIDENTIAL