User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Wall Mount Bracket Kit
Use the wall mount bracket kit if you require a Cisco mounting bracket. The wall mount bracket is attached
to a wall or to the pole clamp bracket assembly and then the router is installed onto the wall mount bracket.
This wall mount bracket is used with the Cisco Pole Mount Kit, on page 25.Note
Figure 10: Wall Mount Bracket Kit Contents
DescriptionQty.NameItem
Mounts onto a wall or to a pole clamp bracket assembly, which is
installed on a pole.
1Wall mount
bracket
1
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 27
Installing the Router
Wall Mount Bracket Kit
REVIEW DRAFT - CISCO CONFIDENTIAL