User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Procedure
Step 1
Position the pole clamp gussets on the pole clamp bracket for the pole diameter you are using and secure each
pole clamp gusset with two M8 x 12 screws (with M8 spring washers). Tighten the screws to 13 to 15 ft lbs
(17.6 to 20.3 Nm). (See the following figure.)
Figure 14: Assembling the Pole Clamp Gusset onto the Pole Clamp Bracket
Pole clamp gusset3M8 x 12 screw (with M8 spring washer)1
Pole clamp bracket4M8 spring washer2
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
32 OL-29732-01
Installing the Router
Assembling the Pole Clamp Bracket and the Pole Clamp Gusset
REVIEW DRAFT - CISCO CONFIDENTIAL