User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Step 5
Tighten the metal bands using the banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=), following
the operating instructions in the box with the tool. Ensure the metal bands are as tight as possible.
Step 6
Place the wall mount bracket onto the pole clamp bracket support bolt (see the following figure).
Step 7
For vertical poles, position the wall mount bracket as shown in the following figure. For horizontal streetlight
poles, rotate the wall mount bracket 90 degree from the position shown in the following figure.
Step 8
Install eight M8 x12 screws (with M8 spring washers) into the bolt holes.
Figure 17: Fixing the Wall Mount Bracket onto the Pole Clamp Bracket Assembly
M8 spring washers2M8 x 12 screws1
Step 9
Hand-tighten the bolts and the nut (do not overtighten).
Step 10
Adjust the top edge of the wall mount bracket until it is horizontal and tighten the screws and the flange nut
(see the above figure) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
The wall mount bracket can be adjusted up to 45 degrees to compensate for tilted horizontal streetlight
poles.
Note
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
36 OL-29732-01
Installing the Router
Mounting the Router onto a Pole
REVIEW DRAFT - CISCO CONFIDENTIAL