User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Step 11
Screw a M8 x12 bolt (with M8 spring washer) into the two support bolt holes on each side the router (see the
following figure). Do not screw the bolt all the way in. Leave a gap of approximately 0.25 in (0.635 cm).
Figure 18: Mounting the Router onto the Wall Mount Bracket on the Pole
Pole4M8 x 12 screws1
Metal straps5M8 spring washers2
—
Wall mount bracket3
Step 12
Position the two bolts on either side of the router with the bolt holes on the wall mount bracket (see the
following figure).
The router should be positioned with the LEDs on the bottom to allow viewing from the ground.Note
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 37
Installing the Router
Mounting the Router onto a Pole
REVIEW DRAFT - CISCO CONFIDENTIAL