User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
The mounting surface, attaching screws, and optional wall anchors must be able to support 13.2
pounds (5.99 kgs [FD chassis model with two SFPs and antenna]) or 15. 8 pounds (7.2 kgs [FA
chassis model with 2 SFPs and antenna]) static weight.
Caution
Figure 21: Wall Mount Bracket for Wall-Mounting
Step 2
Use four customer-supplied screws and optional screw anchors to attach the wall mount bracket to the mounting
surface.
If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the router
to a stucco, cement, or dry wall.
Note
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 41
Installing the Router
Mounting the Router onto a Wall
REVIEW DRAFT - CISCO CONFIDENTIAL