User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Step 3
Hold the router inside the wall mount bracket such that the four bolts on each side of the router are aligned
with the four holes the on each side of the wall mount bracket (see the following figure).
Figure 22: Mounting the Router onto the Wall Mount Bracket on the Wall
Wall mount bracket3M8 x 12 screws1
—
M8 spring washers2
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
42 OL-29732-01
Installing the Router
Mounting the Router onto a Wall
REVIEW DRAFT - CISCO CONFIDENTIAL