User's Manual

•
Appropriate wire-stripping tools
Procedure
Step 1
In the accessory kit, locate the 2-hole lug, 2 pan-head Phillips head screws used to attach the lug to the router,
and the 6-AWG ground wire. (Lug, screws, and wire are part number 32-0629-01.)
Step 2
Set the parts aside.
Step 3
If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7
mm ±0.5 mm) for the ring terminal (see the following figure).
Figure 25: Stripping a Ground Wire
Step 4
Slide the open end of the ground lug over the exposed area of the ground wire.
Step 5
Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground wire
(as shown in the following figure).
Figure 26: Crimping a Ground Lug onto the Ground Wire
Step 6
Use a Phillips head screwdriver to attach the ground lug and wire assembly with the two screws from the
accessory kit.
Step 7
Connect the other end of the ground wire to a suitable grounding point at your site.
Step 8
Repeat steps 3 to 7 to attach the cable to the ground lug on the left side of the router.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
46 OL-29732-01
Installing the Router
Grounding the Router
REVIEW DRAFT - CISCO CONFIDENTIAL