User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Opening the Router Chassis
This section describes how to open the Cisco ASR 901S Series Aggregation Services Router door so that you
can access the interior of the chassis.
To access the router interior, you must open the router door that is located in the lower section of the front
panel of the router chassis. Many of the router hardware installation tasks require you to open the router door
and access the router interior to install or change cables, optical modules, and so on).
Opening the Router Door
The router door can be opened while the router is powered on and connected to the network. Take any safety
precautions described in the Safety Guidelines, on page 13.
The router door features four captive, M8 bolts and two M3 bolts (see following figure).
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 47
Installing the Router
Opening the Router Chassis
REVIEW DRAFT - CISCO CONFIDENTIAL