User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Procedure
Step 1
To open the router door, use the socket wrench to loosen all six captive bolts in the order shown in the following
figure.
Figure 28: Router Door, Showing Captive Bolts
Step 2
After all six bolts are loose, remove the door.
Closing the Router Door
Before You Begin
When closing the door, alternate tightening bolts on each side of the chassis, in the order shown in the section
Opening the Router Door, on page 47, to evenly seal the door.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
OL-29732-01 49
Installing the Router
Closing the Router Door
REVIEW DRAFT - CISCO CONFIDENTIAL