User's Manual
Table Of Contents
- Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
- Contents
- Preface
- Introduction
- Preparing to Install the Router
- Installing the Router
- Mounting Kits Overview
- General Safety Information for Mounting
- Contents of the Mounting Kits
- Customer-Supplied Materials and Tools
- Router-Mounting Instructions
- Connecting the Chassis Ground and Power
- Opening the Router Chassis
- Power Connection Compliance
- Connecting the DC Power Cable to the Router
- AC Power Cable
- Connecting the AC Power Cable to the Router
- Connecting Cables
- Antenna Installation and Replacement
- Powering on the Router
- Enabling Zero Touch Provisioning on the Router
- Using CLIs for Flash Memory and Directory Procedures
- What to Do After Installing the Hardware
- Troubleshooting
- Specifications and Part Numbers
- Cable Specifications
- Site Log
Procedure
Step 1
Remove the antenna port plug located at top of the router.
Step 2
Connect the N-type male connector end of the antenna through the N-type female connector in the antenna
holder.
Step 3
Turn the antenna connector clock-wise to screw the antenna as shown in the following figure.
Figure 33: Installing the Antenna on the Router
N-type female connector2Antenna1
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
60 OL-29732-01
Installing the Router
Installing the Chassis-Mount Antenna on the Router
REVIEW DRAFT - CISCO CONFIDENTIAL